Cisco CRS

PurposeCommand or Action
• Cancel—Remains in the configuration session, without
committing the configuration changes.
Related Topics
Auto-Tunnel Mesh, on page 206
Destination List (Prefix-List), on page 207
Enabling Stateful PCE Client
Perform these steps to enable stateful PCE client.
SUMMARY STEPS
1.
configure
2.
mpls traffic-eng
3.
pce
4.
stateful-client
5.
capabilities { instantiation | update}
6.
Use the commit or end command.
DETAILED STEPS
PurposeCommand or Action
Enters global configuration mode.configure
Example:
RP/0/RP0/CPU0:router# configure
Step 1
Enters MPLS TE configuration mode.mpls traffic-eng
Example:
RP/0/RP0/CPU0:router(config)#mpls traffic-eng
Step 2
Enters PCE configuration mode.pce
Example:
RP/0/RP0/CPU0:router(config-mpls-te)#pce
Step 3
Enters stateful PCE client configuration mode.stateful-client
Step 4
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
331
Implementing MPLS Traffic Engineering
Enabling Stateful PCE Client