Cisco CRS Configuration Guide

PurposeCommand or Action
• Cancel—Remains in the configuration session, without
committing the configuration changes.
Configuring LMP for GMPLS UNI
To implement LMP configuration for GMPLS UNI, follow these procedures:
Configuring Optical Router ID
Perform this task to enable GMPLS UNI LMP functionality and to configure LMP unicast router ID.
SUMMARY STEPS
1.
configure
2.
lmp
3.
gmpls optical-uni
4.
router-id ipv4 unicast address
5.
Use the commit or end command.
DETAILED STEPS
PurposeCommand or Action
Enters global configuration mode.configure
Example:
RP/0/RP0/CPU0:router# configure
Step 1
Enters LMP configuration mode.lmp
Example:
RP/0/RP0/CPU0:router(config)# lmp
Step 2
Enters GMPLS UNI configuration submode.gmpls optical-uni
Example:
RP/0/RP0/CPU0:router(config-lmp)# gmpls
Step 3
optical-uni
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
384
Implementing GMPLS UNI
Configuring LMP for GMPLS UNI

Cisco CRS Specifications

General

Brand	Cisco
Model	CRS
Category	Network Router
Language	English