Cisco CRS

PurposeCommand or Action
window-size 33
commit—Saves the configuration changes and remains within the
configuration session.
Use the commit or end command.
Step 4
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the configuration
session.
• No—Exits the configuration session without committing the
configuration changes.
• Cancel—Remains in the configuration session, without committing
the configuration changes.
Related Topics
Guidelines for Window-Size and Out-of-Sequence Messages, on page 122
RSVP Authentication by Using All the Modes: Example, on page 152
RSVP Authentication for an Interface: Example, on page 151
Configuring an Interface for RSVP Authentication
These tasks describe how to configure an interface for RSVP authentication:
Specifying the RSVP Authentication Keychain in Interface Mode
Perform this task to specify RSVP authentication keychain in interface mode.
You must configure a keychain first (see Cisco IOS XR System Security Configuration Guide for the Cisco CRS
Router).
SUMMARY STEPS
1.
configure
2.
rsvp interface type interface-path-id
3.
authentication
4.
key-source key-chain key-chain-name
5.
Use the commit or end command.
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
137
Implementing RSVP for MPLS-TE and MPLS O-UNI
Configuring an Interface for RSVP Authentication