Cisco CRS - Configuring Destinations for the Tunnel Interface

PurposeCommand or Action
Verifies the multicast static mapping.
show mrib ipv6 route source-address
Example:
RP/0/RP0/CPU0:router# show mrib ipv6 route ff35::1
Step 7
Related Topics
Point-to-Multipoint RSVP-TE , on page 195
Configure Point-to-Multipoint for the Source: Example, on page 363
Configure the Point-to-Multipoint Solution: Example, on page 364
Enabling Multicast Routing on the Router, on page 307
Configuring Destinations for the Tunnel Interface
Perform this task to configure three destinations for the tunnel interface for Point-to-Multipoint (P2MP).
These variations are listed to ensure that the destination and path option configurations are separate from the
tunnel interface.
•
Different path option is used for different destinations. This task shows three destinations.
•
Explicit path option is based on an ID or a name.
•
Default path option is similar to the Point-to-Point (P2P) LSP.
Before You Begin
These prerequisites are required to configure destinations for the tunnel interface.
•
Multicast routing must be enabled on both the tunnel-mte interface and customer-facing interface from
the source.
•
Static-group must be configured on the tunnel-mte interface to forward specified multicast traffic over
P2MP LSP.
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
311
Implementing MPLS Traffic Engineering
Configuring Point-to-Multipoint TE