PurposeCommand or Action
commit—Saves the configuration changes and remains within
the configuration session.
Use the commit or end command.
Step 6
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without committing
the configuration changes.
• Cancel—Remains in the configuration session, without
committing the configuration changes.
Displays the attributes that are defined in the attribute-set for
the link.
show mpls traffic-eng attribute-set
Example:
RP/0/RP0/CPU0:router# show mpls traffic-eng
attribute-set
Step 7
Displays the attribute-set path option information on a specific
tunnel.
show mpls traffic-eng tunnelsdetail
Example:
RP/0/RP0/CPU0:router# show mpls traffic-eng
tunnels detail
Step 8
Related Topics
Path Option Attributes, on page 204
Configuration Hierarchy of Path Option Attributes, on page 204
Traffic Engineering Bandwidth and Bandwidth Pools, on page 205
Path Option Switchover, on page 205
Path Option and Path Protection, on page 206
Configuring Auto-Tunnel Mesh Tunnel ID
Perform this activity to configure the tunnel ID range that can be allocated to Auto-tunnel mesh tunnels.
SUMMARY STEPS
1.
configure
2.
mpls traffic-eng
3.
auto-tunnel mesh
4.
tunnel-id min value max value
5.
Use the commit or end command.
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
323
Implementing MPLS Traffic Engineering
Configuring Auto-Tunnel Mesh Tunnel ID
To Next Page
Loading...
Need help?
General
