Cisco CRS Configuration Guide

PurposeCommand or Action
Configures or updates a LMP neighbor and its associated
parameters.
lmp neighbor name
Example:
RP/0/RP0/CPU0:router(config-mpls-te)# lmp
Step 3
neighbor OXC1
Disables dynamic LMP procedures for the specified neighbor,
including LMP hello and LMP link summary. This command
lmp static
Example:
RP/0/RP0/CPU0:router(config-mpls-te-nbr-0XC1)#
Step 4
is used for neighbors that do not support dynamic LMP
procedures.
lmp static
Configures a routable IPCC.ipcc routed
Example:
RP/0/RP0/CPU0:router(config-mpls-te-nbr-OXC1)#
Step 5
ipcc routed
Configures the remote node ID for an LMP neighbor. The
node ID value must be an IPv4 address.
remote node-id node-id
Example:
RP/0/RP0/CPU0:router(config-mpls-te-nbr-0XC1)#
Step 6
remote node-id 2.2.2.2
commit—Saves the configuration changes and remains within
the configuration session.
Use the commit or end command.
Step 7
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without committing
the configuration changes.
• Cancel—Remains in the configuration session, without
committing the configuration changes.
Configuring Remote TE Link Adjacency Information for Numbered Links
Perform this task to configure remote TE link adjacency information for numbered links.
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
254
Implementing MPLS Traffic Engineering
Configuring GMPLS

Cisco CRS Specifications

General

Brand	Cisco
Model	CRS
Category	Network Router
Language	English