Bandwidth Constraint Models
IETF DS-TE mode provides support for the RDM and MAM bandwidth constraints models. Both models
support up to two bandwidth pools.
Cisco IOS XR software provides global configuration for the switching between bandwidth constraint models.
Both models can be configured on a single interface to preconfigure the bandwidth constraints before swapping
to an alternate bandwidth constraint model.
NSF is not guaranteed when you change the bandwidth constraint model or configuration information.Note
By default, RDM is the default bandwidth constraint model used in both pre-standard and IETF mode.
Maximum Allocation Bandwidth Constraint Model
The MAM constraint model has the following characteristics:
•
Easy to use and intuitive.
•
Isolation across class types.
•
Simultaneously achieves isolation, bandwidth efficiency, and protection against QoS degradation.
Related Topics
Configuring an IETF DS-TE Tunnel Using MAM, on page 235
Russian Doll Bandwidth Constraint Model
The RDM constraint model has these characteristics:
•
Allows greater sharing of bandwidth among different class types.
•
Ensures bandwidth efficiency simultaneously and protection against QoS degradation of all class types.
•
Specifies that it is used in conjunction with preemption to simultaneously achieve isolation across
class-types such that each class-type is guaranteed its share of bandwidth, bandwidth efficiency, and
protection against QoS degradation of all class types.
We recommend that RDM not be used in DS-TE environments in which the use of preemption is precluded.
Although RDM ensures bandwidth efficiency and protection against QoS degradation of class types, it
does guarantee isolation across class types.
Note
Related Topics
Configuring an IETF DS-TE Tunnel Using RDM, on page 233
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
173
Implementing MPLS Traffic Engineering
Differentiated Services Traffic Engineering
To Next Page
Loading...
Need help?
General
