PurposeCommand or Action
neighbor nbr1
Specifies the optical interface address for an LMP link for
a GMPLS UNI controller.
link-id ipv4 unicast address
Example:
RP/0/RP0/CPU0:router(config-lmp-gmpls-uni-cntl)#
Step 6
link-id ipv4 unicast 10.2.2.4
Specifies the neighbor's optical address of an LMP link for
a GMPLS UNI controller.
neighbor link-id ipv4 unicast address
Example:
RP/0/RP0/CPU0:router(config-lmp-gmpls-uni-cntl)#
Step 7
neighbor link-id ipv4 unicast 10.10.4.4
Specifies the neighbor's optical interface ID of an LMP link
for a GMPLS UNI controller.
neighbor interface-id unnumbered interface-id
Example:
RP/0/RP0/CPU0:router(config-lmp-gmpls-uni-cntl)#
Step 8
neighbor interface-id unnumbered 17
commit—Saves the configuration changes and remains
within the configuration session.
Use the commit or end command.
Step 9
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without
committing the configuration changes.
• Cancel—Remains in the configuration session,
without committing the configuration changes.
Configuring RSVP Optical Refresh Interval and Missed Count
Perform this task to configure optical refresh interval under the RSVP controller submode and to configure
the number of missed refresh messages allowed before optical tunnel states are deleted.
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
388
Implementing GMPLS UNI
Configuring RSVP Optical Refresh Interval and Missed Count
To Next Page
Loading...
Need help?
General
