Cisco CRS

SUMMARY STEPS
1.
configure
2.
explicit-path name name
3.
index index-id next-address [loose] ipv4 unicast ip-address
4.
Use the commit or end command.
DETAILED STEPS
PurposeCommand or Action
Enters global configuration mode.configure
Example:
RP/0/RP0/CPU0:router# configure
Step 1
Enters a name for the explicit path.
explicit-path name name
Example:
RP/0/RP0/CPU0:router(config)# explicit-path
Step 2
name interarea1
Includes an address in an IP explicit path of a tunnel.
index index-id next-address [loose] ipv4 unicast
ip-address
Step 3
Example:
RP/0/RP0/CPU0:router(config-expl-path)#
index 1 next-address loose ipv4 unicast
10.10.10.10
commit—Saves the configuration changes and remains within
the configuration session.
Use the commit or end command.
Step 4
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without committing
the configuration changes.
• Cancel—Remains in the configuration session, without
committing the configuration changes.
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
276
Implementing MPLS Traffic Engineering
Configuring Explicit Paths with ABRs Configured as Loose Addresses