Cisco CRS

interface GigabitEthernet0/0/0/0
!
interface GigabitEthernet0/0/0/1
!
interface GigabitEthernet0/0/0/2
!
interface GigabitEthernet0/0/0/1.2
!
interface GigabitEthernet0/0/0/2.2
!
!
mpls ldp
router-id 192.168.1.2
nsr
graceful-restart
interface GigabitEthernet0/0/0/0
!
interface GigabitEthernet0/0/0/1
!
interface GigabitEthernet0/0/0/1.2
!
interface GigabitEthernet0/0/0/2
!
interface GigabitEthernet0/0/0/2.2
!
!
multicast-routing
address-family ipv4
core-tree-protocol rsvp-te
ssm range ssm
static-rpf 172.1.1.1 32 mpls 192.168.1.1
static-rpf 172.3.1.1 32 mpls 192.168.1.3
static-rpf 172.4.1.1 32 mpls 192.168.1.4
interface all enable
!
!
router igmp
!
interface tunnel-mte221
static-group 232.2.2.1 172.2.1.1
!
interface tunnel-mte222
static-group 232.2.2.2 172.2.1.1
!
interface GigabitEthernet0/0/0/0
static-group 232.1.2.1 172.1.1.1
static-group 232.1.2.2 172.1.1.1
static-group 232.3.2.1 172.3.1.1
static-group 232.3.2.2 172.3.1.1
static-group 232.4.2.1 172.4.1.1
static-group 232.4.2.2 172.4.1.1
!
!
end
Related Topics
Enabling Multicast Routing on the Router, on page 307
Point-to-Multipoint Traffic-Engineering Overview, on page 193
Configuring the Static Group for the Point-to-Multipoint Interface, on page 309
Point-to-Multipoint RSVP-TE , on page 195
Configuring Destinations for the Tunnel Interface, on page 311
Path Option for Point-to-Multipoint RSVP-TE, on page 196
Logging Per Destinations for Point-to-Multipoint , on page 316
Point-to-Multipoint Traffic-Engineering Overview, on page 193
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
367
Implementing MPLS Traffic Engineering
Configure Point-to-Multipoint TE: Examples