Redistributing MPLS LDP Routes into BGP 67
Enabling MLDP 69
Enabling MLDP Make-Before-Break 70
Enabling MLDP MoFRR 71
Enabling MLDP Recursive FEC 73
Enabling MLDP Static Multipoint to Multipoint LSP 74
Enabling MLDP Static Point to Multipoint LSP 76
Disabling MLDP 78
Configuration Examples for Implementing MPLS LDP 79
Configuring LDP with Graceful Restart: Example 79
Configuring LDP Discovery: Example 79
Configuring LDP Link: Example 80
Configuring LDP Discovery for Targeted Hellos: Example 80
Configuring Label Advertisement (Outbound Filtering): Example 80
Configuring LDP Neighbors: Example 81
Configuring LDP Forwarding: Example 81
Configuring LDP Nonstop Forwarding with Graceful Restart: Example 82
Configuring Label Acceptance (Inbound Filtering): Example 82
Configuring Local Label Allocation Control: Example 82
Configuring LDP Session Protection: Example 83
Configuring LDP IGP Synchronization—OSPF: Example 83
Configuring LDP IGP Synchronization—ISIS: Example 83
Configuring LDP Auto-Configuration: Example 84
Configure IP LDP Fast Reroute Loop Free Alternate: Examples 84
Verify IP LDP Fast Reroute Loop Free Alternate: Example 86
MPLS LDP CSC for Multiple VRFs Configuration: Examples 88
Additional References 99
CHAPTER 3
Implementing MPLS Static Labeling 101
Enable MPLS Encapsulation on an Interface 102
Define a Range for Static MPLS Labels 103
Setup a Static LSP 104
Allocate Static MPLS Label to an IP Prefix and Configure a LSP 105
Allocate Static MPLS Label for a Specific VRF 107
Verify MPLS Static Bindings 108
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
v
Contents
To Next Page
Loading...
Need help?
General
