Cisco D9854 Installation And Configuration Guide

Setup Menu
131
Menu Item
Description
Parameters
PID
If mapping this PID (Act is set
to Map), select the output PID
number.
1 to 8190
PSI Table Settings
Note: The table settings are only available if you selected Ctl by Table in the PSI
Options menu.
Setting
Mode Options
Description
Default
PAT
Pass, Drop, Regen
Program Association
Table
Pass
CAT
Pass, Drop, Regen
Conditional Access Table
Pass
PMT
Pass, Drop, Regen
Program Map Table
Pass
TSDT
Pass, Drop
Transport Stream
Description Table
Pass
NIT
Pass, Drop, Regen, PwRC
Network Information
Table
Pass
NITO
Pass, Drop, PwRC
Network Information
Table - Other
Pass
SDT
Pass, Drop, Regen, PwRC
Service Description Table
Pass
SDTO
Pass, Drop, PwRC
Service Description Table
- Other
Pass
BAT
Pass, Drop, PwRC
Bouquet Association
Table
Pass
EIT
Pass, Drop
Event Information Table
Pass
TDT
Pass, Drop
Time and Date Table
Pass
RST
Pass, Drop
Running Status Table
Pass
TOT
Pass, Drop
Time Offset Table
Pass
DIT
Pass, Drop
Discontinuity
Information Table
Pass
SIT
Pass, Drop
Selection Information
Table
Pass
ECM
Pass, Drop
Entitlement Control
Message
Pass
EMM
Pass, Drop
Entitlement Management
Message
Pass

Cisco D9854 Specifications

General

Model	D9854
Category	Receiver
Output	ASI, IP
Decoding	MPEG-2
Conditional Access	BISS
Receiver Type	Professional IRD
解密	DVB-CSA, BISS, AES
Input Frequency Range	950 MHz to 2150 MHz
Modulation Formats	QPSK, 8PSK
Symbol Rate	1 to 45 Msps
Power Supply	100-240 VAC, 50/60 Hz
Power Consumption	40W (typical)
Operating Temperature	0°C