EasyManuals Logo

Cisco D9854 Installation And Configuration Guide

Cisco D9854
440 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #49 background imageLoading...
Page #49 background image
25
Introduction
This chapter contains the information for technicians installing the
Cisco D9854/D9854-I Advanced Program Receiver.
Qualified Personnel
Only appropriately qualified and trained service personnel should
attempt to install, operate, or maintain the D9854/D9854-I receiver.
WARNING:
Allow only authorized and qualified service personnel to install,
operate, maintain, and service this product. Otherwise, personal
injury or equipment damage may occur.
3 Chapter 3
Installation
In This Chapter
Rack Installation .................................................................................26
Installing the D9854/D9854-I Receiver.............................................28
D9854/D9854-I Receiver Rear Connector Pa nel ..............................30
Connecting the Input/Output Signals..............................................32
Setting Admin User Privileges via a Telnet/SSH Connection........38
Common Interface Modules ..............................................................41

Table of Contents

Other manuals for Cisco D9854

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco D9854 and is the answer not in the manual?

Cisco D9854 Specifications

General IconGeneral
ModelD9854
CategoryReceiver
OutputASI, IP
DecodingMPEG-2
Conditional AccessBISS
Receiver TypeProfessional IRD
解密DVB-CSA, BISS, AES
Input Frequency Range950 MHz to 2150 MHz
Modulation FormatsQPSK, 8PSK
Symbol Rate1 to 45 Msps
Power Supply100-240 VAC, 50/60 Hz
Power Consumption40W (typical)
Operating Temperature0°C

Related product manuals