DPM Default Settings for Different Output Modes
DPM Default Settings for Different Output Modes
The DPM parameters are preset to default settings for each DPM Output Mode.
The default settings for particular Output modes have been preset to optimize the
output when PID mapping is required. If the DPM parameters are changed to values
which switch the receiver to Full DPM Control, the receiver may enter a condition
where conflicts in the settings may occur, which may require manual manipulation
of the DPM or output parameters to obtain the desired output.
The fields labeled “Any” in the table below are not used, in which case, the Output
Mode will not change if the parameter is changed. However, if you change any of
the other parameters listed in the table for the MAP output modes, the Output Mode
will change to Full DPM Control.
To Next Page
Loading...
Need help?
General
