Setting up Input Information
Setting up the BISS Mode
1 From the user interface of the D9854/D9854-I, choose Input > BISS. The BISS
page is displayed.
2 From the BISS Mode drop-down list, choose the Basic Interoperable Scrambling
System mode for the receiver (Mode 1 or Mode E). All channels assigned to the
PE identified as BISS CA-controlled in the PMT will be decrypted.
3 If you selected BISS Mode 1, enter a fixed 12-character BISS Mode-1 session word
in the BISS Mode-1 Session Word field. Once entered it cannot be viewed and it
is only displayed as asterisks (*). Contact your program provider for the session
word.
4 If you selected BISS Mode E, enter the 16-character BISS Mode-E session word in
the BISS Mode-E Encrypted Session Word field and the 14-character BISS
Mode-E injected ID in the BISS Mode-E Injected ID field. Once entered, neither
of these values can be viewed and it is only displayed as asterisks. Contact your
program provider for the respective session word and/or injected ID.
5 Click Apply.
To Next Page
Loading...
Need help?
General
