Configuring System Settings
Setting up SNMP Information and Trap Destinations
1 From the user interface of the D9854/D9854-I, choose System Settings > IP
Settings > SNMP. The SNMP page is displayed.
2 In the Read Only Community String and the Read Write Community String
fields, enter public (default) or custom string. Set the password to read/write
data from a device and to display diagnostic traps/alarms. This is used when
communicating with a device within an SNMP environment. To set a custom
community string, enter an alphanumeric character string up to 31 alphanumeric
characters in length identifying the password for the device.
Note: The community string is case-sensitive.
3 In the System Name, System Location, and System Contact fields, enter the
system name, location, and contact information of the D9854/D9854-I receiver.
The system information is sent to the MIB browser, if applicable. The MIB
Browser is a third party software used to manage SNMP requests. For more
information, contact Cisco Services.
4 Click Apply.
To Next Page
Loading...
