Cisco D9854 Installation And Configuration Guide

Chapter 5 Web GUI Setup and Monitoring
272
3 Click Apply.
To Add a Static Multicast Filtering
1 Click Add Row in the Static Multicast Filtering table.
2 Type the IP Address that sets the destination for multicast MPE data, in the
range from 224.0.0.0 to 239.0.0.0.
Note: If MPE Data Filter Mode is set to Forward All or Forward Filtered, all the
unicast MPE data will be forwarded, regardless of the Static Multicast Filtering
table.
3 Click Save.
To edit/delete an existing multicast filter address, select the address entry by
clicking on the radio button. Click Edit and make the necessary changes, or click
Delete to remove the address from the Static Multicast Filtering list.

Cisco D9854 Specifications

General

Model	D9854
Category	Receiver
Output	ASI, IP
Decoding	MPEG-2
Conditional Access	BISS
Receiver Type	Professional IRD
解密	DVB-CSA, BISS, AES
Input Frequency Range	950 MHz to 2150 MHz
Modulation Formats	QPSK, 8PSK
Symbol Rate	1 to 45 Msps
Power Supply	100-240 VAC, 50/60 Hz
Power Consumption	40W (typical)
Operating Temperature	0°C