Cisco D9854 Installation And Configuration Guide

Chapter 5 Web GUI Setup and Monitoring
224
Configuring Transport Stream Information
Configuring the ASI Output
1 From the user interface of the D9854/D9854-I, choose Transport Stream > ASI
Output. The ASI Output page is displayed.
Note: After you make any changes, a successfully updated (session open)
message appears. The changes are displayed, but not saved. You must click
Apply to save and apply the changes.
Note: Any changes made to the ASI DPM values will automatically change the
Mode Status to Edited by User.
2 From the Rate Control drop-down list, choose the output rate control. The
following table describes the affect each of the settings has on the output bit rate:

Cisco D9854 Specifications

General

Model	D9854
Category	Receiver
Output	ASI, IP
Decoding	MPEG-2
Conditional Access	BISS
Receiver Type	Professional IRD
解密	DVB-CSA, BISS, AES
Input Frequency Range	950 MHz to 2150 MHz
Modulation Formats	QPSK, 8PSK
Symbol Rate	1 to 45 Msps
Power Supply	100-240 VAC, 50/60 Hz
Power Consumption	40W (typical)
Operating Temperature	0°C