Chapter 6 Service and Maintenance
D9854/D9854-I Receiver Alarm Messages
The Alarm LED on the front panel indicates whether the unit has triggered an alarm
or warning. A solid red signal for five seconds indicates a warning, and a flashing
red signal indicates an alarm. For more information, see About the Front Panel (on
page 44).
The status of the D9854/D9854-I receiver and its immediate surroundings is
reported to the front panel in the form of messages and alarms. You can enable or
disable messages in the Alarm/Warning settings.
The following table shows an alphabetical list of the available messages and their
default alarm status. The Set Messages and Clear Messages are displayed in the
Warning History when the messages are set or cleared respectively.
Note: Only alarm conditions can be used to trigger rear panel relays to control
external alarm equipment. Warnings are not associated with relay operation.
We recommend that you collect the debug support data prior to contacting Cisco
customer support for any D9854/D9854-I issues.
Alarms
PROD incomplete
or PSB non-
compliant
Cause: Production
Access Reset
command was not
issued after
production
programming was
completed.
Remedy: The
Access Reset
command should
be issued by the
user with PROD
credentials if the
device has not yet
been shipped to
the customer.
Otherwise, the
customer must
reset credentials
using the front
panel.
Device is in the
WEAK state
after
production
programming
is complete.
To Next Page
Loading...
Need help?
General
