Configuring Transport Stream Information
View ing the MPEG ov er IP Output Status
The MOIP Output Status area (MPEG over IP Output Main and Stream pages)
displays the actual output bit rates (including FEC) for each data port, the combined
user rate for all the configured streams (including FEC), MPEG over IP TS overflow
status, and whether there are critical MPEG over IP engine errors.
Configuring the DPM MPEGoIP Output Details
The following procedure defines all the available fields. For a typical setup of the
DPM, see Typical set up for Digital Program Mapping (DPM) (on page 258).
Note: After you make any changes, a successfully updated (session open) message
appears. The changes are displayed, but not saved. You must click Apply to save
and apply the changes.
To Next Page
Loading...
