Cisco D9854 Installation And Configuration Guide

Installing the D9854/D9854-I Receiver
29
Connecting AC Power to the D9854/D9854-I Receiver
1 Connect the power cord (supplied with the D9854/D9854-I receiver) between the
rear panel power receptacle and a 100 to 120/200 to 240 V AC power outlet.
2 Make sure that the power cable is connected to protective ground. See
Grounding (on page 28) for more information.
The unit is equipped with one power supply located in the rear of the chassis. Note
the location of the power supply in the event of alarms/warnings resulting in
replacement of a power supply. Alarm messages appear in the Message Log.

Cisco D9854 Specifications

General

Model	D9854
Category	Receiver
Output	ASI, IP
Decoding	MPEG-2
Conditional Access	BISS
Receiver Type	Professional IRD
解密	DVB-CSA, BISS, AES
Input Frequency Range	950 MHz to 2150 MHz
Modulation Formats	QPSK, 8PSK
Symbol Rate	1 to 45 Msps
Power Supply	100-240 VAC, 50/60 Hz
Power Consumption	40W (typical)
Operating Temperature	0°C