Chapter 5 Web GUI Setup and Monitoring
Setting up SI Receive Parameters
Note: If the unit is in a disaster recovery or NIT retune mode, an error message is
displayed, informing you that any changes made to the page will interrupt the
disaster recovery or NIT retune process. The error message appears when you load,
refresh, or apply changes to the page. For more information on NIT retune, see NIT
Retune Recovery (on page 11). For more information on disaster recovery, see
Disaster Recovery (on page 8).
1 From the user interface of the D9854/D9854-I, choose Input > SI Receive Setup.
The SI Receive Setup page is displayed.
2 In the Custom Tuning Mode area, from the Acquisition Mode drop-down list,
choose the tables required for the service list creation and signal acquisition. The
selections are Auto, Basic, or Custom. The default is Basic. If you choose Basic, it
requires NIT to be present. If you choose Auto, it uses all the available service list
tables and it will acquire if any table is present.
To Next Page
Loading...
Need help?
General
