Reacquiring the Network Information.............................................................. 168
Viewing the Current Input Status ..................................................................... 168
Setting up the ASI Input..................................................................................... 170
Configuring the IP Input .................................................................................... 171
Setting up SI Receive Parameters ...................................................................... 178
Setting up Muting Threshold Controls ............................................................. 181
Viewing the Input Status.................................................................................... 183
Configuring the Disaster Recovery Settings ..................................................... 183
Viewing the Disaster Recovery Status .............................................................. 187
Setting up the Channel Selections ..................................................................... 192
Viewing the Channel Status............................................................................... 193
Configuring the Common Interface (CI) Information ..................................... 195
Viewing the Common Interface (CI) Status...................................................... 199
Viewing the CA Status ....................................................................................... 200
Setting up the BISS Mode................................................................................... 201
Viewing the PSI Tables ....................................................................................... 202
Viewing PSI Frequency Table Information....................................................... 203
Viewing the PSI Channels.................................................................................. 204
Viewing the PID Input Status ............................................................................ 205
Setting up Audio and Video Information...................................................................... 206
Setting up the Video Parameters ....................................................................... 206
Setting up Captions ............................................................................................ 208
Setting up Subtitles ............................................................................................. 209
Setting up the VBI ............................................................................................... 211
Setting up Audio Parameters............................................................................. 212
Setting up Cueing Parameters ........................................................................... 217
Setting up Cue Tone Test ................................................................................... 219
Setting up Cue Tones.......................................................................................... 220
Setting up SDI ..................................................................................................... 221
Setting up Services to be Decoded by the D9854/D9854-I Receiver............... 223
Configuring Transport Stream Information.................................................................. 224
Configuring the ASI Output .............................................................................. 224
Configuring the DPM ASI Details ..................................................................... 230
Viewing the ASI Output Transport Status........................................................ 236
Configuring the MPEGoIP Output.................................................................... 237
Configuring the DPM MPEGoIP Output Details ............................................. 251
Viewing the MPEG Output Transport Status................................................... 258
Typical set up for Digital Program Mapping (DPM) ....................................... 258
Configuring System Settings .......................................................................................... 261
Viewing the System Identification .................................................................... 261
Viewing Hardware Features and Software License Information ................... 262
Setting up IP Information................................................................................... 263
Setting up IP Unicast Routing Information ...................................................... 269
Configuring the MPE Settings ........................................................................... 271
Setting up SNMP Information and Trap Destinations .................................... 273
Configuring Time/Clock Settings ..................................................................... 275
Viewing the Alarm/Warning Status................................................................. 277
To Next Page
Loading...
