Configuring Transport Stream Information
MAP Service
Channels Only
This is similar to MAP Passthrough, except that only channels
applied to program entries are available on the output. If the input
is tuned to a valid channel, the PEs are automatically set to Map.
Otherwise, the PEs are automatically set to Drop.
Note: If the PE is mapped, it uses the last valid input. The output
map (for example, output channel PMT) does not change
automatically if the input or channel number is changed.
The output will be generated according to the DPM settings on the
MPEG over IP Digital Program Mapping page. This is a manual
control setting.
SPTS Service
Channels Only
(D9854-I only)
The service channel is passed with the same channel number,
PMT PID, and ES PID numbers.
SPTS MAP Service
Channels Only
(D9854-I only)
The service channel is mapped to the preconfigured channel
number, PMT, and ES PIDs.
SPTS Full DPM
Control (D9854-I
only)
The output will be generated according to the DPM settings on the
MPEG over IP Digital Program Mapping page. This is a manual
control setting.
A message appears to confirm that you want to resynchronize the output
changes and PIDs to match the selected input programs. Click Yes.
If a conflict occurs and Enable Auto Map for Collision is set to No, a detailed list
of all the conflicts is displayed in the Output Channel and PID Conflicts table
when you click View Conflicts. You can then resolve the conflicts manually. If a
conflict occurs and Enable Auto Map for Collision is set to Yes, a message that
the conflicts will be fixed automatically and the Output Channel and PID
Conflicts table is empty.
To Next Page
Loading...
Need help?
General
