EasyManuals Logo

Cisco D9854 Installation And Configuration Guide

Cisco D9854
440 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #265 background imageLoading...
Page #265 background image
Configuring Transport Stream Information
241
9 In the SAP Destination UDP Port field, set the SAP destination port number (1
to 65534). This is the UDP port where the SAP announcements are sent, if
required.
Note: We recommend that you do not change the default SAP port of 9875.
10 Click Apply.
The following MPEG over IP Output parameters are displayed for the D9854-I only:
In addition to the MPEG over IP Output parameters, you can configured the FEC
Scheme.

Table of Contents

Other manuals for Cisco D9854

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco D9854 and is the answer not in the manual?

Cisco D9854 Specifications

General IconGeneral
ModelD9854
CategoryReceiver
OutputASI, IP
DecodingMPEG-2
Conditional AccessBISS
Receiver TypeProfessional IRD
解密DVB-CSA, BISS, AES
Input Frequency Range950 MHz to 2150 MHz
Modulation FormatsQPSK, 8PSK
Symbol Rate1 to 45 Msps
Power Supply100-240 VAC, 50/60 Hz
Power Consumption40W (typical)
Operating Temperature0°C

Related product manuals