Configuring Transport Stream Information
3 From the Enable Fixed Output drop-down list, choose Yes for the DPM to assign
new values for all the output channels and PIDs according to the Fixed Output
Options table when you Resynchronize All. Click Fixed Output Options to
configure the MoIP Fixed Output Options:
a From the Use Input Channel Numbers drop-down list, choose Yes to use the
input channel numbers. Otherwise, choose No (default) to use the first
channel and channel offset assigned below.
i In the First Channel Number field, set the first PE channel number to
use. By default, the channel is set to 1.
ii In the Channel Numbers Offset field, set the subsequent PE channel
numbers. For example, if the First Channel Number is set to 100 and the
Channel Numbers Offset is set to 10, then the first channel number is 100,
and the second channel number is 110.
b From the Use Input PMT PID Numbers drop-down list, choose Yes to use
the input PMT PID number. Otherwise, choose No (default) to use the first
PE PID number and PID offset number assigned below.
i In the First Channel First ES PID Number field, set the first PE PMT PID
number. The default is 1701.
ii In the PMT PID Numbers Offset field, set the offset of the subsequent PE
PMT PID numbers. For example, if the First Channel First ES PID
Number is set to 1701 and the PMT PID Numbers Offset is set to 1, then
the first PMT PID number is 1701, and the second PMT PID number is
1702.
To Next Page
Loading...
Need help?
General
