Cisco D9854 Installation And Configuration Guide

Chapter 5 Web GUI Setup and Monitoring
246
The following is an example of the D9854-I MPEG over IP page:
The following table describes the stream information:
Stream Details
Description
Stream
Type of stream.
The D9854 has one stream only (Multi Program Transport Stream
[MPTS]).
The D9854-I has up to 16 streams. If No Output, Passthrough,
Service Channels Only, MAP Passthrough, MAP Service
Channels Only, or Full DPM Control is selected as the Output
Mode, you can configure the Multi Program Transport Stream
(MPTS). PE2 to PE16 are not applicable.
If SPTS Service Channels Only, SPTS MAP Service Channels
Only, or SPTS Full DPM Control is selected as the Output Mode,
you can configure PE1 to PE16 streams. Each PE creates its own
transport stream for the assigned service channel and ES PIDs.

Cisco D9854 Specifications

General

Model	D9854
Category	Receiver
Output	ASI, IP
Decoding	MPEG-2
Conditional Access	BISS
Receiver Type	Professional IRD
解密	DVB-CSA, BISS, AES
Input Frequency Range	950 MHz to 2150 MHz
Modulation Formats	QPSK, 8PSK
Symbol Rate	1 to 45 Msps
Power Supply	100-240 VAC, 50/60 Hz
Power Consumption	40W (typical)
Operating Temperature	0°C