Configuring System Settings
System Logs
From the Syslog drop-down list, choose the logging protocol to use (Syslog TCP or
Syslog UDP). The Legacy option is used by Cisco Services only. Choose Disable to
disable system logging.
If Syslog TCP or Syslog UDP is selected, set the IP address of the server in the
Syslog Server IP Address field and the server UDP or TCP port number in the
Syslog Server Port field.
We highly recommend that you use the following syslog servers:
Syslog-ng - Balabit for Linux (http://www.balabit.com/network-
security/syslog-ng/opensource-logging-system)
Syslog Watcher - SnmpSoft for Windows
(http://www.snmpsoft.com/downloads.html)
The following is an example of a syslog:
Setting Up Redundancy Controls
Note: This feature is for the D9854-I only.
The Redundancy Control area allows you to configure redundancy for MPEG over
IP and MPE outputs when an active port fails due to a physical connectivity loss.
The data port 1 is labeled as TS OUT 2, and the data port 2 is labeled as TS OUT 3 on
the rear connector panel. For more information, see D9854/D9854-I Receiver Rear
Connector Panel (on page 30).
1 In the IP Settings page (System Settings > IP Settings), refer to the Redundancy
Control area.
To Next Page
Loading...
Need help?
General
