Cisco D9854 Installation And Configuration Guide

Chapter 5 Web GUI Setup and Monitoring
270
To add a unicast route:
a Click Add Row.
b Type the Destination IP Address that sets the destination for the unicast
route.
c Set the number of CIDR (Classless Inter-Domain Routing) bits in the network
Mask (8 to 30).
d Set the Gateway Address on the Network, used to expose the receiver to a
WAN. The following table shows the most commonly used Subnet mask
values to enter for a chosen IP address mask, which will depend on the size
of your network.
Mask
Subnet Mask
8
255.0.0.0
16
255.255.0.0
24
255.255.255.0
e Check the Port 1 or Port 2 check box. The management port is port 1 and the
data port is port 2.
5 Click Save. The routing information is displayed in the Installed Unicast Routes
table. If the configured routing information has an inactive port, then the routing
information is not displayed in the Installed Unicast Routes table.

Cisco D9854 Specifications

General

Model	D9854
Category	Receiver
Output	ASI, IP
Decoding	MPEG-2
Conditional Access	BISS
Receiver Type	Professional IRD
解密	DVB-CSA, BISS, AES
Input Frequency Range	950 MHz to 2150 MHz
Modulation Formats	QPSK, 8PSK
Symbol Rate	1 to 45 Msps
Power Supply	100-240 VAC, 50/60 Hz
Power Consumption	40W (typical)
Operating Temperature	0°C