Cisco D9854 Installation And Configuration Guide

Configuring System Settings
281
Note: Enable/Disable must be set to Yes for the Relay and Trap settings to be
functional.
5 If current warning is enabled, choose Yes from the Trap drop-down list and the
SNMP trap message will be sent when the warning is set or cleared.
Note: No is a read only value that indicates the setting is Yes, but is currently
being suppressed because the warning is disabled (Enb is set to No).
6 If current warning is enabled, choose Yes from the Relay drop-down list for the
rear panel alarm relay to be triggered when the warning is set or cleared.
Note: No is a read only value that indicates the setting is Yes, but is currently
being suppressed because the warning is disabled (Enb is set to No).
7 Click Apply.

Cisco D9854 Specifications

General

Model	D9854
Category	Receiver
Output	ASI, IP
Decoding	MPEG-2
Conditional Access	BISS
Receiver Type	Professional IRD
解密	DVB-CSA, BISS, AES
Input Frequency Range	950 MHz to 2150 MHz
Modulation Formats	QPSK, 8PSK
Symbol Rate	1 to 45 Msps
Power Supply	100-240 VAC, 50/60 Hz
Power Consumption	40W (typical)
Operating Temperature	0°C