Cisco D9854 Installation And Configuration Guide

Chapter 6 Service and Maintenance
348
Warning
Message
Type
Message
Cause/Remedy
Description
ID
SFN MIP
Counter (D9854
with Single
Frequency
Network only)
Set
Transport Error
SFN MIP Input
Output
Difference
Cause: Extra packets
may have been inserted,
or packets were deleted
between the input and
output of the receiver.
Remedy: Clear
warnings, reset unit, and
notify Cisco Services if
the problem persists.
Input and output
packet counts on MIP
reception are different.
41500
SFN MIP
Counter (D9854
with Single
Frequency
Network only)
Clear
Transport Error
SFN MIP Input
Output
Difference
Cleared
–
–
41500
Transport Error
Set
Continuity Count
Error
Cause: Possible uplink
or signal issue.
Remedy: Clear
warnings, reset the unit,
and notify Cisco
Services if the problem
persists.
Transport packet
continuity count
jumped. Possible
packet loss.
42000
Transport Error
Set
Buffer Overflow
Cause: Possible uplink
or signal issue.
Remedy: Clear
warnings, reset the unit,
and notify Cisco
Services if the problem
persists.
The transport stream
is faster than the
maximum buffer or
the decode engines are
having difficulty
handling the data sent
to them.
42000
Transport Error
Set
Transport Error
Indicator
Cause: Possible uplink
or signal issue.
Remedy: Clear
warnings, reset the unit,
and notify Cisco
Services if the problem
persists.
Transport packets are
marked as "errored"
upstream of the
decoder.
42000

Cisco D9854 Specifications

General

Model	D9854
Category	Receiver
Output	ASI, IP
Decoding	MPEG-2
Conditional Access	BISS
Receiver Type	Professional IRD
解密	DVB-CSA, BISS, AES
Input Frequency Range	950 MHz to 2150 MHz
Modulation Formats	QPSK, 8PSK
Symbol Rate	1 to 45 Msps
Power Supply	100-240 VAC, 50/60 Hz
Power Consumption	40W (typical)
Operating Temperature	0°C