5-11
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 5 Configuring the Management Interface and Security
Configuring the Available Interfaces
Monitoring Management Interface IP Filtering
Use this command to display the following information for management interface IP filtering.
• IP fragment filter enabled or disabled
• configured attack threshold (permitted and not-permitted IP addresses)
• configured end of attack threshold (permitted and not-permitted IP addresses)
• burst size in seconds (permitted and not-permitted IP addresses)
Step 1 From the SCE> prompt, type show ip filter and press Enter.
Configuring the Available Interfaces
The system allows you to configure the Telnet and SNMP interfaces according to the manner in which
you are planning to manage the SCE platform and the external components of the system.
• Configuring TACACS+ Authentication, Authorization, and Accounting, page 5-11
• Configuring Access Control Lists (ACLs), page 5-26
• Configuring the Telnet Interface, page 5-28
• Configuring the SSH Server, page 5-30
• Enabling the SNMP Interface, page 5-33
Configuring TACACS+ Authentication, Authorization, and Accounting
• Information About TACACS+ Authentication, Authorization, and Accounting, page 5-12
• Configuring the SCE Platform TACACS+ Client, page 5-15
• How to Manage the User Database, page 5-19
• Configuring AAA Login Authentication, page 5-22
• Configuring AAA Privilege Level Authorization Methods, page 5-24
• Configuring AAA Accounting, page 5-25
• Monitoring TACACS+ Servers, page 5-25
• Monitoring TACACS+ Users, page 5-26
To Next Page
Loading...
