Cisco SCE2020-4XGBE-SM - Displaying the System Uptime; Displaying the System Uptime: Example; Rebooting and Shutting down the SCE Platform; Rebooting the SCE Platform

3-15
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 3 Operations
Displaying the System Uptime
Displaying the System Uptime
Use this command to see how long the system has been running since the last reboot.
Step 1 From the SCE> prompt, type show system-uptime and press Enter
Displaying the System Uptime: Example
SCE>show system-uptime
SCE uptime is 21 minutes, 37 seconds
SCE>
Rebooting and Shutting Down the SCE Platform
• Rebooting the SCE Platform, page 3-15
• Shutting Down the SCE Platform, page 3-16
Rebooting the SCE Platform
Rebooting the SCE platform is required after installing a new firmware, in order for that firmware to take
effect. There might be other occasions where rebooting the SCE platform is necessary.
Note When the SCE restarts, it loads the startup configuration, so all changes made in the running
configuration will be lost. You are advised to save the running configuration before performing reload,
as described in Saving the Configuration Settings, page 3-4.
Step 1 From the SCE# prompt, type reload and press Enter
A confirmation message appears.
Step 2 Type Y to confirm the reboot request and press Enter.
Rebooting the SCE Platform: Example
SCE# reload
Are you sure? y
the system is about to reboot, this will end your CLI session