12-20
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 12 Value Added Services (VAS) Traffic Forwarding
Configuring VAS Traffic Forwarding
How to Configure a VAS Server
• Options, page 12-20
• How to Enable a VAS Server, page 12-20
• How to Disable a VAS Server, page 12-21
• How to Restore all VAS Server Properties to Default, page 12-21
The user must define the VAS servers. Each VAS server has the following parameters:
• Admin-mode — Enabled or disabled.
• Health Check mode — Enabled or Disabled
• Health Check ports
• VLAN tag
Use the following commands to perform these operations for individual VAS servers:
• Enable a specified VAS server
• Disable a specified VAS server
• Define the VLAN tag for a specified VAS server
• Enable or disable the Health Check for a VAS server
• Define the source and destination ports to use for the Health Check.
• Delete all properties for a specified VAS server. The server returns to the default state, which is
enabled. However, it is not operational since it does not have VLAN.
Note that a VAS server is not operational until the VLAN tag is defined, even if the server itself is
enabled.
Options
The following option is available:
• number — The number of the VAS server.
How to Enable a VAS Server
Use this command to enable a VAS server.
Note The server is not operational until a VLAN tag has also been defined
Step 1 From the SCE(config if)# prompt, type VAS-traffic-forwarding VAS server-id number enable and
press Enter.
To Next Page
Loading...
