Cisco SCE2020-4XGBE-SM - How to View Information about the Peer SCE Platform; How to View the Current Connection Status of the SCE Platform; How to Configure the Link Mode

7-5
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 7 Configuring the Connection
How to Configure the Link Mode
How to View Information about the Peer SCE Platform
Step 1 From the SCE> prompt, type show interface linecard 0 cascade peer-sce-information and press Enter.
Viewing Information about the Peer SCE Platform: Example
The following example shows typical output of this command.
SCE>enable 5
Password:<cisco>
SCE>show interface linecard 0
cascade peer-sce-information
Peer SCE's IP address is 10.10.10.10
How to View the Current Connection Status of the SCE Platform
The output of this command displays information about the correct way to connect the cascade interfaces
in addition to displaying the connection status as displayed by the show interface linecard
connection-mode command.
Step 1 From the SCE> prompt, type show interface linecard 0 cascade connection-status and press Enter.
Monitoring the Connection Status: Example
The following example shows the output of this command in the case of two cascaded SCE platforms
where the cascade interfaces have not been connected correctly.
SCE>enable 5
Password:<cisco>
SCE>show interface linecard 0 cascade connection-status
SCE is improperly connected to peer SCE
Please verify that each cascade port is connected to the correct port of the peer SCE.
Note that in the current topology, the SCE must be connected to its peer as follows:
Port 0/3 must be connected to port 0/4 at peer
Port 0/4 must be connected to port 0/3 at peer
SCE>
How to Configure the Link Mode
• About the Link Mode, page 7-6
• Options, page 7-6