5-5
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 5 Configuring the Management Interface and Security
Configuring the Management Port Physical Parameters
Configuring the Management Interface Speed and Duplex Parameters
This section presents sample procedures that describe how to configure the speed and the duplex of the
Management Interface.
Both these parameters must be configured separately for each port.
• Interface State Relationship to Speed and Duplex, page 5-5
• How to Configure the Speed of the Management Interface, page 5-5
• How to Configure the Duplex Operation of the Management Interface, page 5-6
Interface State Relationship to Speed and Duplex
Table 5-1 summarizes the relationship between the interface state and speed and duplex.
How to Configure the Speed of the Management Interface
• Options, page 5-5
• Configuring the Speed of the Management Interface: Example, page 5-6
Options
The following options are available:
• speed — speed in Mbps of the currently selected management port (0/1 or 0/2):
–
10
–
100
–
auto (default) — auto-negotiation (do not force speed on the link)
If the duplex parameter is configured to auto, changing the speed parameter has no effect (see ).
Step 1 From the SCE(config if)# prompt, type speed 10|100|auto and press Enter.
Specify the desired speed option.
Table 5-1 Interface State Relationship to Speed and Duplex
Speed Duplex Actual FE Interface State
Auto Auto Auto negotiation
Auto Full Auto negotiation
Auto Half Auto negotiation
10 Auto Auto-negotiation (duplex only)
10 Full 10 Mbps and full duplex
10 Half 10 Mbps and half duplex
100 Auto Auto-negotiation (speed only)
100 Full 100 Mbps and full duplex
100 Half 100 Mbps and half duplex
To Next Page
Loading...
