13-25
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 13 MPLS/VPN Support
Managing MPLS/VPN Support
Managing VPNs
Use the p3vpn utility to manage VPNs.
• Options, page 13-25
• How to Add a New MPLS-based VPN, page 13-25
• How to Remove a VPN, page 13-25
• How to Display VPN Information, page 13-25
• How to Manage VPN Mappings, page 13-26
Options
The following options are available:
• VPN-Name — The name assigned to the VPN when it was added, or, if adding a VPN, the name to
be assigned to it.
• RT@PE-IP — The mapping assigned to the VPN. Multiple mappings can be specified using a
comma.
–
RT = the route target of the VPN, specified using the ASN:n notation or the IP:n notation
Note that the Route Distinguisher may be specified rather than the route target
–
PE-IP = the loopback IP of the PE router connected to that VPN
How to Add a New MPLS-based VPN
Step 1 From the shell prompt, type the following command: p3vpn --add --vpn=VPN-Name
--mpls-vpn=RT@PE,(RT@PE2, RT@PE3,....
How to Remove a VPN
Step 1 From the shell prompt, type the following command: p3vpn --remove --vpn=VPN-Name
How to Display VPN Information
• To List All Existing VPNs, page 13-25
• To List All Subscribers for a Specified VPN, page 13-26
• To Display the Mappings for a Specified VPN, page 13-26
To List All Existing VPNs
Step 1 From the shell prompt, type the following command: p3vpn -–show-all
To Next Page
Loading...
