Cisco SCE2020-4XGBE-SM - Monitoring VAS Traffic Forwarding; How to Display Global VAS Status and Configuration; Example

12-28
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 12 Value Added Services (VAS) Traffic Forwarding
Monitoring VAS Traffic Forwarding
Monitoring VAS Traffic Forwarding
• How to Display Global VAS Status and Configuration, page 12-28
• How to Display Operational and Configuration Information for a Specific VAS Server Group,
page 12-29
• How to Display Operational and Configuration Information for All VAS Server Groups, page 12-29
• How to Display Operational and Configuration Information for a Specific VAS Server, page 12-29
• How to Display Operational and Configuration Information for All VAS Servers, page 12-30
• How to Display the VAS Servers Used by a Specified Subscriber, page 12-30
• How to Display Health Check Counters for a Specified VAS Server, page 12-30
• How to Display Health Check Counters for All VAS Servers, page 12-31
• How to Clear the Health Check Counters for a Specified VAS Server, page 12-31
• How to Clear the Health Check Counters for All VAS Servers, page 12-31
• How to Display Bandwidth per VAS Server and VAS Direction, page 12-31
Use these commands to display the following information for VAS configuration and operational status
summary.
• Global VAS status summary — VAS mode, the traffic link used
• VAS Server Groups information summary — operational status, number of configured servers,
number of current active servers.
This information may be displayed for a specific server group or all server groups
• VAS servers information summary — operational status, Health Check operational status, number
of subscribers attached to this server.
This information may be displayed for a specific server or all servers
• Bandwidth per VAS server and VAS direction (to VAS / from VAS)
• VAS health check counters
Sample outputs are included.
How to Display Global VAS Status and Configuration
Step 1 From the SCE> prompt, type show interface linecard 0 VAS-traffic-forwarding and press Enter.
Example
SCE>show interface linecard 0 VAS-traffic-forwarding
VAS traffic forwarding is enabled
VAS traffic link configured: Link-1 actual: Link-1