Cisco SCE2020-4XGBE-SM - How to Upgrade an Application; How to Undo an Upgrade of an Application; How to Display the Last Pqi File that was Installed

3-11
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 3 Operations
Managing Application Files
How to Upgrade an Application
Step 1 From the SCE(config if)# prompt, type pqi upgrade file filename [options] and press Enter.
Upgrades the current application with the specified pqi file using the installation options specified (if
any). Use the show pqi file filename info command to display installation options available for the
application file. (See How to Display Information about an Application File, page 3-10.)
Note that this may take up to five minutes.
How to Undo an Upgrade of an Application
Step 1 From the SCE(config if)# prompt, type pqi rollback file filename and press Enter.
Undoes the upgrade of the specified pqi file.
Note that this may take up to five minutes.
How to Display the Last pqi File that was Installed
Step 1 From the SCE> prompt, type pqi last-installed and press Enter