xxxvi
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
About this Guide
Introduction
Related Publications
Your SCE platform and the software running on it contain extensive features and functionality, which
are documented in the following resources:
• For further information regarding the Service Control CLI and a complete listing of all CLI
commands, refer to the Cisco SCE 2000 and SCE 1000 CLI Command Reference
• For information regarding configuring the Cisco SCE8000 platform, refer to thethe Cisco SCE8000
10GBE Software Configuration Guide or the Cisco SCE8000 GBE Software Configuration Guide.
• For complete installation information, including initial configuration, refer to the relevant
installation guide:
–
Cisco SCE 2000 4xGBE Installation and Configuration Guide
–
Cisco SCE 2000 4/8xFE Installation and Configuration Guide
–
Cisco SCE 1000 2xGBE Installation and Configuration Guide
• For initial installation and startup information, refer to the relevant quick start guide:
–
Cisco SCE 2000 4xGBE Quick Start Guide
–
Cisco SCE 2000 4/8xFE Quick Start Guide
–
Cisco SCE 1000 2xGBE Quick Start Guide
• For international agency compliance, safety, and statutory information for wide-area network
(WAN) interfaces for the SCE 2000 platform, refer to the regulatory and safety information
document:
–
Regulatory Compliance and Safety Information for Cisco Service Control Engine (SCE).
• For installation and configuration of the other components of the Service Control Management Suite
refer to:
–
Cisco SCMS Subscriber Management User Guide
–
Cisco SCMS Collection Manager User Guide
–
Cisco Service Control Application for Broadband User Guide
–
Cisco Service Control Application Reporter User Guide
• To view Cisco documentation or obtain general information about the documentation, refer to the
following sources:
–
Obtaining Documentation and Submitting a Service Request, page -xxxviii
–
The Cisco Information Packet that shipped with your SCE 2000 platform.
To Next Page
Loading...
