Cisco SCE2020-4XGBE-SM - How to Disable DNS Lookup; How to Enable DNS Lookup; Configuring Name Servers; How to Define Domain Name Servers

5-68
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 5 Configuring the Management Interface and Security
Configuring Domain Name Server (DNS) Settings
How to Enable DNS Lookup
Step 1 From the SCE(config)# prompt, type ip domain-lookup and press Enter.
Enables DNS lookup.
How to Disable DNS Lookup
Step 1 From the SCE(config)# prompt, type no ip domain-lookup and press Enter.
Configuring Name Servers
• Options, page 5-68
• How to Define Domain Name Servers, page 5-68
• How to Remove a Domain Name Server, page 5-69
• How to Remove All Domain Name Servers, page 5-69
Options
The following options are available:
• server-ip-address — The IP address of the domain name server. You can define more than one DNS
server (server-ip-address1, server-ip-address2, server-ip-address3)
How to Define Domain Name Servers
Use this command to specify the address of one or more name servers to use for name and address
resolution.
Step 1 From the SCE(config)# prompt, type ip name-server server-address1 [server-address2
[server-address3]] and press Enter.
Defines the servers at the specified addresses as domain name servers.
Defining Domain Name Servers: Example
The following example shows how to configure the two name server (DNS) IP addresses.
SCE(config)#ip name-server 10.1.1.60 10.1.1.61