4-15
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 4 Utilities
Flow Capture
How to Stop a Flow Capture
Step 1 From the SCE(config if)# prompt, type flow-capture stop and press Enter.
Monitoring the Flow Capture
Use the following command to monitor the flow capture process. It displays the following information:
• status of the recording process
• current target file size
• number of packets captured
• number of packets lost
• configured values of the different controllers
How to Monitor the Flow Capture
Step 1 From the SCE> prompt, type show interface linecard 0 flow-capture and press Enter.
To Next Page
Loading...
