Cisco SCE2020-4XGBE-SM - Displaying Subscribers: by Mapping (IP Address, VPN, VLAN ID, or MPLS;VPN)

9-21
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 9 Managing Subscribers
Monitoring Subscribers
How to display the number of subscribers that are greater than or less than a specified value of a subscriber
property
Options
The following options are available:
• propertyname — name of the subscriber property to match
• property-val — value of that subscriber property to match
Step 1 From the SCE> prompt, type show interface linecard 0 subscriber amount property
propertyname greater-than|less-than property-val and press Enter.
How to display the number of subscribers that match a specified prefix
Options
The following options are available:
• prefix — subscriber prefix to match
Step 1 From the SCE> prompt, type show interface linecard 0 subscriber amount prefix prefix and press
Enter.
Displaying Subscribers: By Mapping (IP Address, VPN, VLAN ID, or MPLS/VPN)
• How to display subscribers that are mapped to a specified IP address, or range of IP addresses,
page 9-22
• How to display subscribers that are mapped to IP addresses that are included in a given IP address
or IP range, page 9-22
• How to display subscribers that are mapped to a specified VLAN ID, page 9-22
• How to display subscribers that are mapped to a specified MPLS/VPN, page 9-22
• How to display subscribers with no mapping, page 9-23
• How to display the number of subscribers that are mapped to a specified VLAN ID, page 9-23
• How to display the number of subscribers with no mapping, page 9-23
You can display the subscribers who are mapped to any of the following:
• A specified IP address, or range of IP addresses (may be within a specified VPN)
• IP addresses intersecting a given IP address or IP range (may be within a specified VPN)
• A specified VLAN ID
• A specified MPLS/VPN
• no mapping
You can also display just the number of subscribers with a specified mapping, rather than listing the
actual subscribers.