Cisco SCE2020-4XGBE-SM - Configuring the Behavior of the SCE Platform in Case of Failure of the SM; Configuring the SM-SCE Platform Connection Timeout; Options

7-11
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 7 Configuring the Connection
Configuring the SCE Platform/SM Connection
Configuring the Behavior of the SCE Platform in Case of Failure of the SM
Options
The following options are available:
• force-failure — Force failure of SCE platform. The SCE platform then acts according to the
behavior configured for the failure state.
• remove-mappings — Remove all current subscriber mappings.
• shut — The SCE platform shuts down and quits providing service.
• none (default ) — Take no action.
Step 1 From the SCE(config if)# prompt, type subscriber sm-connection-failure action
[force-failure|none|remove-mappings|shut] and press Enter.
Configures the action of the SCE platform in the case of failure of the connection to the SM.
Configuring the SM-SCE Platform Connection Timeout
You can also configure the timeout interval; the length of time that the SM-SCE platform connection is
disrupted before a failed connection is recognized and the configured behavior is applied.
Options
The following option is available:
• interval — the timeout interval in seconds
Step 1 From the SCE(config if)# prompt, type subscriber sm-connection-failure timeout interval and press
Enter.
Configures the connection timeout.