Cisco SCE2020-4XGBE-SM - How to Configure the VAS Traffic Link; How to Revert to the Default Link for VAS Traffic; How to Select the Link for VAS Traffic; Options

12-19
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 12 Value Added Services (VAS) Traffic Forwarding
Configuring VAS Traffic Forwarding
Step 1 From the SCA BB console, remove all the VAS table associations to packages and apply the changed
policy.
Step 2 From the SCE(config if)# prompt, type shutdown and press Enter.
Shuts down the line card.
Step 3 From the SCE(config if)# prompt, type no VAS-traffic-forwarding and press Enter.
Disables VAS traffic forwarding.
Step 4 From the SCE(config if)# prompt, type no shutdown and press Enter.
Re-enables the line card.
How to Configure the VAS Traffic Link
• Options, page 12-19
• How to Select the Link for VAS Traffic, page 12-19
• How to Revert to the Default Link for VAS Traffic, page 12-19
By default, the VAS traffic is transmitted on Link 1. If the VAS servers are connected on Link 0, you
must configure the VAS traffic link to Link 0.
To configure the link for VAS over 10G, see VAS over 10G, page 12-32).
Note The VAS traffic link should be in Forwarding mode.
Options
The following option is available:
• VAS traffic-link {link-0|link-1} — The link number on which to transmit VAS traffic
– Default — Link 1
How to Select the Link for VAS Traffic
Step 1 From the SCE(config if)# prompt, type VAS-traffic-forwarding traffic-link {link-0|link-1} and press
Enter.
How to Revert to the Default Link for VAS Traffic
Step 1 From the SCE(config if)# prompt, type no VAS-traffic-forwarding traffic-link and press Enter.