6-14
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 6 Configuring the Line Interface
Configuring VLAN Translation
How to Display the IPinIP Configuration
Step 1 From the SCE# prompt, type show interface linecard 0 ip-tunnel IPinIP and press Enter.
Displays the current configuration for the specified tunnel option.
How to Display the Logged-in VPNs
Options
The following options are available
• vpn-name —The name of a specific currently logged-in VPN for which to display details.
• all-names —Use this keyword to display all the VPN names that are currently logged into the
system.
Step 1 From the SCE> prompt, type show interface linecard 0 VPN {name vpn-name | all-names} and press
Enter.
How to Display the Asymmetric L2 Support Mode
Step 1 From the SCE# prompt, type show interface linecard 0 asymmetric-L2-support and press Enter.
Configuring VLAN Translation
• VLAN Translation Features and Limitations, page 6-15
• Setting the VLAN Translation Constant, page 6-16
• How to Disable VLAN Translation, page 6-17
• How to Monitor VLAN Translation, page 6-17
Some topologies require the SCE platform to be able to translate between different VLAN tags.
Figure 6-2 illustrates an example of such a system, in which one router acts as a dispatcher, forwarding
traffic and performing load balancing between two SCE 2000 platforms.
To Next Page
Loading...
