Cisco SCE2020-4XGBE-SM - Monitoring the SCMP Environment; Options

14-16
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 14 Managing the SCMP
Monitoring the SCMP Environment
Options
The following options are available:
• times — The maximum number of times the RADIUS client can try unsuccessfully to send a
message.
– Default = 3
• timeout (optional) — Timeout interval for retransmitting a message, in seconds
– Default = 1 second
Step 1 From the SCE(config)# prompt, type ip radius-client retry limit times [timeout timeout] and press
Enter.
Monitoring the SCMP Environment
• Monitoring the SCMP, page 14-16
• Monitoring the RADIUS Client, page 14-18
You can monitor the following components of the SCMP environment:
• SCMP
• RADIUS client
Monitoring the SCMP
• Options, page 14-16
• How to display the general SCMP configuration, page 14-17
• How to display the configuration all currently defined SCMP peer devices, page 14-17
• How to display the configuration for a specified SCMP peer device, page 14-17
• How to display the statistics for all SCMP peer devices, page 14-17
• How to display the statistics for a specified SCMP peer device, page 14-18
Use the following commands to monitor the SCMP. These commands provide the following information:
• General SCMP configuration
• Configuration of all currently defined SCMP peer devices.
• Configuration of a specified SCMP peer device.
• Statistics for either all SCMP peer devices or a specified SCMP peer device.
Options
The following options are available:
• device-name — The name of the specific SCMP peer device for which to display the configuration
or statistics.