Cisco SCE2020-4XGBE-SM - Clearing the Subscriber Database Counters; Displaying Subscribers

9-18
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 9 Managing Subscribers
Monitoring Subscribers
============
Peak number of subscribers with mappings: 2
Peak number occurred at: 14:56:55 ISR MON June 9 2007
Peak number cleared at: 15:29:39 ISR MON June 9 2007
Event counters:
===============
Subscriber introduced: 2.
Subscriber pulled: 0.
Subscriber aged: 0.
Pull-request notifications sent: 0.
State notifications sent: 0.
Logout notifications sent: 0.
Subscriber mapping TIR contradictions: 0
Clearing the Subscriber Database Counters
Step 1 From the SCE# prompt, type clear interface linecard 0 subscriber db counters and press Enter.
Clears the total and maximum counters.
Displaying Subscribers
• Displaying Subscribers: All Current Subscriber Names, page 9-19
• Displaying Subscribers: By Subscriber Property or Prefix, page 9-19
• Displaying Subscribers: By Mapping (IP Address, VPN, VLAN ID, or MPLS/VPN), page 9-21
You can display the names of all subscribers.
You can also display specific subscriber name(s) that meet various criteria:
• A subscriber property is equal to, larger than, or smaller than a specified value.
• Subscriber name matches a specific prefix or suffix.
• Mapped to a specified IP address range (may be within a specified VPN).
• Mapped to a specified VLAN ID.
• Mapped to a specified MPLS/VPN.
Use the following commands to display subscribers:
• show interface linecard 0 subscriber all-names
• show interface linecard 0 subscriber [amount] [prefix ‘prefix’] [property ‘propertyname’
equals|greater-than|less-than ‘property-val’]
• show interface linecard 0 subscriber [amount] prefix ‘prefix’
• show interface linecard 0 subscriber [amount] suffix ‘suffix’
• show interface linecard 0 subscriber mapping IP ‘iprange’ [VPN 'vpn-name']
• show interface linecard 0 subscriber [amount] mapping intersecting IP ‘iprange’ [VPN 'vpn-name']
• show interface linecard 0 subscriber mapping VLAN-id ‘VLAN-id’
• show interface linecard 0 subscriber mapping MPLS-VPN PE-ID 'pe-id' BGP-label 'bgp-label'