9-16
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 9 Managing Subscribers
Monitoring Subscribers
Subscribers may be introduced to the SCE platform via the SCE platform CLI or via the Subscriber
Manager. The monitoring commands may be used to monitor all subscribers and subscriber information,
regardless of how the subscribers were introduced to the system.
Note that these commands are all in Viewer mode. Make sure that you are in the proper mode and that
the SCE> prompt appears in the command line. Note also that you must specify ‘linecard 0’ in these
commands.
How to Monitor the Subscriber Database
• How to Display the Subscriber Database Counters, page 9-17
• Clearing the Subscriber Database Counters, page 9-18
Use the following commands to display statistics about the subscriber database, and to clear the “total”
and “maximum” counters.
• show interface linecard 0 subscriber db counters
The following counters are displayed:
–
Current number of subscribers
–
Current number of introduced subscribers
–
Current number of anonymous subscribers
–
Current number of active subscribers (with active traffic sessions)
–
Current number of subscribers with mappings
–
Current number of IP mappings
–
Current number of vlan mappings
–
Max number of subscribers that can be introduced
–
Max number of subscribers with mappings
–
Max number of subscribers with mappings date / time
–
Total aggregated number introduced
–
Total number of aged subscribers
–
Total number of pull events
–
Number of traffic sessions currently assigned to the default subscriber
• clear interface linecard 0 subscriber db counters
To Next Page
Loading...
