5-15
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 5 Configuring the Management Interface and Security
Configuring the Available Interfaces
1. For complete details on server configuration, refer to the appropriate configuration guide for the
particular TACACS+ server that you will be using.
2. Configure the SCE client to work with TACACS+ server:
–
hostname of the server
–
port number
–
shared encryption key (the configured encryption key must match the encryption key configured
on the server in order for the client and server to communicate.)
3. (Optional) Configure the local database, if used.
–
add new users
If the local database and TACACS+ are both configured, it is recommended to configure the same
user names in both TACACS+ and the local database. This will allow the users to access the SCE
platform in case of TACACS+ server failure.
Note If TACACS+ is used as the login method, the TACACS+ username is used automatically in the enable
command. Therefore, it is important to configure the same usernames in both TACACS+ and the local
database so that the enable command can recognize this username.
–
specify the password
–
define the privilege level
4. Configure the authentication methods on the SCE platform.
–
login authentication methods
–
privilege level authorization methods
5. Review the configuration.
Use the " show running-config " command to view the configuration.
Configuring the SCE Platform TACACS+ Client
• How to Add a new TACACS+ Server Host, page 5-16
• How to Remove a TACACS+ Server Host, page 5-17
• How to Configure the Global Default Key, page 5-17
• How to Configure the Global Default Timeout, page 5-18
To Next Page
Loading...
